Are internal pocket doors right for homes in Angus and Dundee?
The right door depends on the opening, the room and the way you use the garden. Here is how internal pocket doors tend to work out in practice:
Where an Angus and Dundee house has solid brick internal walls, a pocket door is still possible, but expect a new stud lining and more making good than in a timber partition.
Before arranging a survey at your Angus and Dundee home, check whether the wall beside the doorway carries radiators, sockets or pipes, because those decide whether internal pocket doors will fit.
- The door leaf can be chosen to match the other internal doors in the house, such as painted panels, oak veneer or a glazed design, so it does not look out of place.
- Reclaims the floor area a hinged door needs to swing, which in a small bathroom or cloakroom can be the difference between fitting a vanity unit and going without.
- Flush pulls sit level with the face of the door so the leaf can slide fully into the pocket, with a small edge pull to draw it back out again.
Guide prices for internal pocket doors in Angus and Dundee
The table shows guide prices for common sizes, supplied and fitted, including VAT. Your exact price is fixed in a written quote once the opening in your home has been measured.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| Single pocket door | 1 leaf | £895–£1,595 |
| Double pocket door | 2 leaves | £1,695–£2,795 |
Every size is on the internal pocket doors page.
Daylight and glass in Angus and Dundee
Internal glazed doors are mostly about borrowed light. In Angus and Dundee, winter daylight lasts only around 6 h 48 min, so a glass door between a bright extension and a darker hallway or dining room can make a noticeable difference from November to February.
Towns we cover in Angus and Dundee
We survey and fit internal pocket doors in 8 towns across Angus and Dundee, including the DD1, DD10, DD11, DD5, DD7, DD8 postcode districts.
Approvals in Scotland
Internal doors do not normally need a building warrant in Scotland. We only supply safety glass for glazed doors, and any change to a structural wall would need a warrant, so we check the wall at survey.
Questions about internal pocket doors in Angus and Dundee
Do you fit internal pocket doors in Angus and Dundee?
Yes. We survey and fit internal pocket doors in Angus and Dundee and across Angus and Dundee, including Dundee and Arbroath. Start with a guide price online or call us, and we will arrange a free survey for a new or replacement door.
How much wall space does a pocket door need?
A pocket door needs a length of clear wall beside the opening that is roughly the width of the door, plus a little extra for the frame. A double pocket door needs that space on both sides. The pocket section must be free of radiators, sockets, switches, pipes and cables, which is often the deciding factor in whether a particular doorway works.
Can I put a light switch on the wall with the pocket?
Not on the pocket section itself, because the door slides through that cavity and there is nowhere to run a cable or fix a back box. Switches and sockets can usually move to the other side of the doorway or to an adjoining wall. We point out any that need moving at survey, and an electrician should relocate them before the pocket frame goes in.
Can a pocket door be fitted into an existing wall?
Yes, a pocket door can usually be fitted into an existing wall, but it involves opening up the wall beside the doorway. In a stud partition we remove the plasterboard, fit the pocket frame and board it again. In a masonry wall the usual approach is a new stud lining, and if the wall is load-bearing, forming the pocket becomes structural work that needs proper assessment and approval first.