External pocket sliding doors across Perth and Kinross
A few practical points decide whether external pocket sliding doors suit a particular room and opening:
If the wall beside your Perth and Kinross patio opening is free of windows, radiators and sockets, it may be long enough to take a pocket so the panels disappear completely.
For a Perth and Kinross extension still at the drawing stage, planning the pocket wall now is far simpler than rebuilding a finished wall later.
- Parked inside the wall, open panels are protected from weather and knocks, and garden furniture can sit right up to the edge of the opening.
- With every panel slid into the wall, the full width of the opening is clear, so the room and terrace join without a fixed panel in the way.
- When closed, a pocket door looks like a large-paned slider, with slim meeting stiles and plenty of glass instead of the many frames of a folding door.
Guide prices for external pocket sliding doors in Perth and Kinross
These figures are for the door supplied and fitted, with the engineer's structural calculations, including VAT. They include forming the opening and the pocket in the wall; Building Control fees are set by your council and are extra. Your price is fixed in a written quote after survey.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| 2.1 m | 1 panel | £7,095–£8,595 |
| 3.0 m | 2 panels | £8,395–£10,295 |
| 4.8 m | 3 panels | £11,095–£13,595 |
| 6.0 m | 3 panels | £12,895–£15,795 |
Every size is on the external pocket sliding doors page.
Daylight and glass in Perth and Kinross
Sun angles matter for big glazed doors. Around Perth and Kinross, midday sun reaches about 57° in summer and drops to about 10° in winter. That low winter sun is free heat through south-facing glass; high summer sun is easier to shade with a roof overhang, and solar-control glass helps where there is none.
Towns we cover in Perth and Kinross
We survey and fit external pocket sliding doors in 7 towns across Perth and Kinross, including the KY13, PH10, PH15, PH16, PH2, PH3 postcode districts.
Approvals in Scotland
A new opening in Scotland is warrant work: the council needs structural information for the beam and opening before building starts, and the finished door must meet the Scottish standards.
Questions about external pocket sliding doors in Perth and Kinross
Do you fit external pocket sliding doors in Perth and Kinross?
Yes. We survey and fit external pocket sliding doors in Perth and Kinross and across Perth and Kinross, including Perth and Aberfeldy. Start with a guide price online or call us, and we will arrange a free survey for a new or replacement door.
How do you maintain rollers inside a wall pocket?
You maintain pocket door rollers through the access panel built into the inside of the pocket wall, which lets the track be vacuumed and the rollers adjusted without opening up the wall. Keep the outside drainage channel clear so water cannot back up into the pocket, and run the panels fully in and out now and then. If a panel starts to rub inside the pocket, a small roller height adjustment through the access panel usually cures it.
How long does an external pocket door project take?
An external pocket door typically takes 6–8 weeks to make after survey sign-off, and the building work to form the opening and pocket typically takes 3–5 days before the door goes in. Fitting the door then takes 1–2 days. Engineer design and Building Regulations approval come first, so the whole project runs longer than a straight door swap.
How much do external pocket sliding doors cost?
External pocket sliding doors start from a guide price of £6,595 for a 1.8 m single-panel door, fitted, inc VAT, at standard 2.1 m height, including forming the wall pocket. A 3 m two-panel door is a guide £8,395–£10,295, and a 6 m three-panel door is around £12,895. Wall construction, glass and finish affect the figure, which is fixed in a written quote after survey.