- Postcode district
- SS1
- Survey
- Free for new and replacement doors
- Typical lead time
- Typically 6–8 weeks for slimline systems after check survey sign-off
- Guide price
- From £5,095 inc VAT
- Nearby
- Rayleigh, Canvey Island, South Benfleet
- Building rules
- England
Is a sliding door for an extension a good fit for your home in Southend-on-Sea?
A few practical points decide whether sliding doors for extensions suit a particular room and opening:
Planning an extension in Southend-on-Sea? Send us the drawings before the steel is ordered, so the beam above the doors can be designed with the door in mind.
If your Southend-on-Sea builder is about to pour the screed, confirm the finished floor level for the threshold first, because it is very hard to change afterwards.
- Setting the finished floor level before the screed goes down allows a low threshold, typically 15–25 mm, or a flush one with a drainage channel outside.
- Being involved at drawing stage means the opening is formed to suit the door, rather than the door being compromised to suit an opening built a few centimetres out.
- Garden rooms benefit from the same approach, with a door sized to the frame and a header designed to carry the roof without pressing down on the door.
How much sun will a door in Southend-on-Sea get?
In Southend-on-Sea the shortest day has roughly 7 h 49 min of daylight and the longest about 16 h 39 min. The noon sun sits near 15° above the horizon in winter and 62° in summer — so glass that faces south collects useful warmth from October to March, while a west-facing door may need solar control to stop it overheating in July.
How much do sliding doors for extensions cost in Southend-on-Sea?
The table shows guide prices for common sizes, supplied and fitted, including VAT. Your exact price is fixed in a written quote once the opening in your Southend-on-Sea home has been measured.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| 1.8 m | 2 panels | £5,095–£6,195 |
| 2.1 m | 2 panels | £5,495–£6,795 |
| 3.0 m | 2 panels | £6,895–£8,395 |
See every size on the sliding doors for extensions page or try the guide price tool.
How fitting works in Southend-on-Sea
Surveys in the SS1 district are booked at a time that suits you. Once the opening is ready and measured, manufacture is typically 6–8 weeks for slimline systems after check survey sign-off; on fitting day the frame is set level and sealed, and the panels are adjusted so they glide properly. Fitting usually takes 1–2 days, scheduled to the build programme.
Rules for sliding doors for extensions in England
In England, sliding doors in a new extension are covered by the extension's own Building Regulations application rather than a separate door notification. Approved Document L limits the glazed area: windows, roof windows and doors should not normally exceed 25% of the extension's floor area plus the area of any windows or doors lost to the extension, unless the extra glass is compensated for elsewhere. The doors must also meet the energy and safety glazing standards.
Specification choices for sliding doors for extensions in Southend-on-Sea
- Flush threshold. A level floor from inside to out, with a drainage channel set into the patio.
- Two-panel slimline. One sliding and one fixed panel, suiting openings up to around 3.6 m depending on the system.
- Corner opening. Sliding panels meeting at a corner with no post, for extensions open on two sides.
Questions about sliding doors for extensions in Southend-on-Sea
Is the price different in Southend-on-Sea?
No. Guide prices for sliding doors for extensions are the same across mainland Britain, including Southend-on-Sea. The fitted price depends on size, system, glass and finish, and any structural work, all fixed in your written quote after survey.
Can you measure from drawings rather than the built opening?
We can quote from drawings, but we manufacture from a check survey of the built opening, because real openings often differ slightly from the plans. Making a large made-to-measure door from drawings alone risks it not fitting. If a programme makes that unavoidable, any arrangement and who carries the risk would be agreed in writing first.
Can you work with my builder and architect?
Yes, working with your builder, architect and structural engineer is the normal way we approach extension doors. We can provide technical details, opening sizes, threshold requirements and fixing information, and attend site for the check survey. Your builder forms the opening and prepares the floor, and our installers fit the doors to the agreed programme.
What sliding doors suit a garden room?
A garden room usually suits a two-panel or three-panel sliding door sized to the front of the building, with a header strong enough to carry the roof without pressing on the frame. Aluminium systems are a common choice because they are stable and need little maintenance. Glass with good insulation helps if the room will be used all year.