Are internal pocket doors right for homes in Buckinghamshire?
Before you settle on a door type, it helps to know what internal pocket doors do well and what to check before you order.
Planning an open-plan kitchen in Buckinghamshire but still want to close it off now and then? A double pocket door gives you both.
Before arranging a survey at your Buckinghamshire home, check whether the wall beside the doorway carries radiators, sockets or pipes, because those decide whether internal pocket doors will fit.
- A double pocket door, with two leaves parting from the centre, opens up a wide doorway between a kitchen and a living area without any doors standing in the room.
- Soft-close dampers can slow the door in its final few centimetres in both directions, stopping it slamming shut or bouncing back out of the pocket.
- Flush pulls sit level with the face of the door so the leaf can slide fully into the pocket, with a small edge pull to draw it back out again.
Guide prices for internal pocket doors in Buckinghamshire
The table shows guide prices for common sizes, supplied and fitted, including VAT. Your exact price is fixed in a written quote once the opening in your home has been measured.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| Single pocket door | 1 leaf | £895–£1,595 |
| Double pocket door | 2 leaves | £1,695–£2,795 |
Every size is on the internal pocket doors page.
Daylight and glass in Buckinghamshire
Internal glazed doors are mostly about borrowed light. In Buckinghamshire, winter daylight lasts only around 7 h 47 min, so a glass door between a bright extension and a darker hallway or dining room can make a noticeable difference from November to February.
Towns we cover in Buckinghamshire
We survey and fit internal pocket doors in 13 towns across Buckinghamshire, including the HP11, HP20, HP27, HP5, HP7, HP9 postcode districts.
Approvals in England
Fitting an internal sliding or pocket door is not usually notifiable building work in England. Approved Document K treats glass in doors as a critical location, so we only supply safety glass for internal doors. If a wall has to be altered to form a pocket, check first whether it is load-bearing.
Questions about internal pocket doors in Buckinghamshire
Can you match other doors and windows in my Buckinghamshire home?
Usually, yes. Most aluminium and uPVC systems come in standard RAL colours and finishes, and we can quote dual colour where the inside and outside need to differ. Bring photos of existing frames to the survey.
How long does it take to fit a pocket door?
Fitting a pocket door typically takes one to two days, depending on whether the wall is stud or masonry and how much needs opening up. New plaster then needs time to dry before it can be decorated. We agree the order of work with you at survey so other trades, such as an electrician or decorator, can be booked around it.
How much does an internal pocket door cost?
Our guide price for a fitted internal pocket door is £895–£1,595 for a single and £1,695–£2,795 for a double, inc VAT at standard height. Where your door falls in that range depends on the leaf, the hardware, the wall construction and how much making good is needed. The final figure is fixed in a written quote after we have surveyed the wall.
Can a pocket door be fitted into an existing wall?
Yes, a pocket door can usually be fitted into an existing wall, but it involves opening up the wall beside the doorway. In a stud partition we remove the plasterboard, fit the pocket frame and board it again. In a masonry wall the usual approach is a new stud lining, and if the wall is load-bearing, forming the pocket becomes structural work that needs proper assessment and approval first.