Are internal pocket doors right for homes in Powys?
Here is what to weigh up if you are considering internal pocket doors for a home in Powys:
In a Powys hallway where three or four doors open into the same small space, swapping one or two for pocket doors can stop them colliding with each other.
Renovating a period property in Powys? Pocket doors can take panelled leaves that echo the existing doors, so the change looks considered rather than out of place.
- Privacy hook locks made for sliding leaves give a bathroom or en suite a door that locks from inside and can still be released from outside in an emergency.
- Top-hung rollers carry the weight of the leaf from above, so there is no floor track to trip over, clean around or catch the vacuum cleaner on.
- Soft-close dampers can slow the door in its final few centimetres in both directions, stopping it slamming shut or bouncing back out of the pocket.
Guide prices for internal pocket doors in Powys
Guide prices are the same across Powys. They cover the door supplied and fitted into a prepared opening, including VAT, with options itemised in your quote.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| Single pocket door | 1 leaf | £895–£1,595 |
| Double pocket door | 2 leaves | £1,695–£2,795 |
Every size is on the internal pocket doors page.
Daylight and glass in Powys
In winter, Powys gets about 7 h 42 min of daylight against 16 h 46 min in June. Internal sliding and pocket doors help by keeping openings clear during the day and closing off rooms for warmth in the evening.
Towns we cover in Powys
We survey and fit internal pocket doors in 10 towns across Powys, including the HR3, LD1, LD2, LD3, LD7, NP8 postcode districts.
Approvals in Wales
Internal sliding and pocket doors are not usually notifiable building work in Wales. We only supply safety glass for glazed doors, and any alteration to a load-bearing wall needs structural advice and approval from Building Control.
Questions about internal pocket doors in Powys
Do you fit internal pocket doors in Powys?
Yes. We survey and fit internal pocket doors in Powys and across Powys, including Brecon and Builth Wells. Start with a guide price online or call us, and we will arrange a free survey for a new or replacement door.
Can I put a light switch on the wall with the pocket?
Not on the pocket section itself, because the door slides through that cavity and there is nowhere to run a cable or fix a back box. Switches and sockets can usually move to the other side of the doorway or to an adjoining wall. We point out any that need moving at survey, and an electrician should relocate them before the pocket frame goes in.
How much wall space does a pocket door need?
A pocket door needs a length of clear wall beside the opening that is roughly the width of the door, plus a little extra for the frame. A double pocket door needs that space on both sides. The pocket section must be free of radiators, sockets, switches, pipes and cables, which is often the deciding factor in whether a particular doorway works.
Can a pocket door be fitted into an existing wall?
Yes, a pocket door can usually be fitted into an existing wall, but it involves opening up the wall beside the doorway. In a stud partition we remove the plasterboard, fit the pocket frame and board it again. In a masonry wall the usual approach is a new stud lining, and if the wall is load-bearing, forming the pocket becomes structural work that needs proper assessment and approval first.