- Postcode district
- BH24
- Survey
- Free for new and replacement doors
- Typical lead time
- Typically 4–6 weeks for aluminium and 2–4 weeks for uPVC after survey sign-off
- Guide price
- From £3,295 inc VAT
- Nearby
- Ferndown, Fordingbridge, Christchurch
- Building rules
- England
What replacement sliding doors offer homes in Ringwood
The right door depends on the opening, the room and the way you use the garden. Here is how replacement sliding doors tend to work out in practice:
Considering a wider door for your Ringwood home while you are replacing it? Weigh up the extra cost of structural work against the gain in glass before deciding.
If the existing opening in your Ringwood home is sound and a sensible size, simply replacing the door gives the biggest improvement for the least disruption.
- Removal and disposal of your old patio door is included in our guide prices, so there is no separate skip or tip run to organise.
- Most two-panel replacements are completed in a single day, so the house is secure again by the evening without the room being out of use for long.
- Certification through a competent person scheme installer, or notification to Building Control, is arranged as part of the job and gives you a record for when you sell.
How much sun will a door in Ringwood get?
Daylight in Ringwood runs from about 7 h 56 min in December to 16 h 31 min in June, with the noon sun at roughly 16° and 63° respectively. Use that to choose your glass: standard low-E double glazing for north and east elevations, and consider solar-control or triple glazing for sunny south and west walls.
What should you budget for replacement sliding doors in Ringwood?
The table shows guide prices for common sizes, supplied and fitted, including VAT. Your exact price is fixed in a written quote once the opening in your Ringwood home has been measured.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| 1.5 m | 2 panels | £3,295–£4,095 |
| 1.8 m | 2 panels | £3,695–£4,495 |
| 3.6 m | 3 panels | £5,595–£6,895 |
See every size on the replacement sliding doors page or try the guide price tool.
What happens when you order replacement sliding doors in Ringwood?
Here is the usual sequence in Ringwood: guide price, free survey, written quote, then manufacture (typically 4–6 weeks for aluminium and 2–4 weeks for uPVC after survey sign-off). Fitting typically takes 1 day for a straight two-panel swap; 1–2 days for larger doors. Nearby, we also survey in Ferndown, Fordingbridge and Christchurch.
Do you need approval in Ringwood?
In England, a replacement sliding door is a controlled fitting under the Building Regulations. In an existing home, a door with more than 60% glazing must reach a U-value of 1.4 W/m²K or better (or a Doorset Energy Rating of band C) under Approved Document L, and glass in doors must be safety glazing under Approved Document K. We arrange compliance through a competent person scheme installer or by notifying Building Control, and you receive the certificate.
Choosing the specification
- Upgraded glass. Triple, laminated, solar-control or obscure glass to suit the elevation.
- New internal cill or board. A fresh window board or reveal lining to finish the inside neatly.
- Lower threshold. A reduced-height sill where floor and outside levels allow, with suitable drainage.
Questions about replacement sliding doors in Ringwood
Is the price different in Ringwood?
No. Guide prices for replacement sliding doors are the same across mainland Britain, including Ringwood. The fitted price depends on size, system, glass and finish, and any structural work, all fixed in your written quote after survey.
Do I need planning permission to replace a sliding door?
Replacing doors on a house is usually permitted development, so no planning application is needed, as long as the new doors are similar in appearance to the existing ones. Flats, listed buildings and properties covered by an Article 4 direction may need consent. Our planning guide explains more.
What if there is no proper lintel above my old door?
Occasionally an old door frame turns out to be carrying some load because the support above the opening is inadequate or missing. We check the head of the opening at survey and again when the old frame comes out. If extra support is needed, we explain why, what it involves and what it costs before any further work goes ahead.
Will the new door have a lower threshold?
A lower threshold may be possible on a replacement, depending on the floor level inside, the height of the patio or ground outside and how the opening was built. Low thresholds are typically 15–25 mm. A flush threshold needs a drainage channel outside so rain cannot run in. We check levels at survey and tell you what is realistic.