- Postcode district
- ZE1
- Survey
- Free, area covered by arrangement
- Typical lead time
- Typically 4–6 weeks for aluminium and 2–4 weeks for uPVC after survey sign-off
- Guide price
- From £3,295 inc VAT
- Building rules
- Scotland
Are replacement sliding doors right for your Lerwick home?
These are the points a surveyor will go through with you when you choose replacement sliding doors for a home in Lerwick:
If the existing opening in your Lerwick home is sound and a sensible size, simply replacing the door gives the biggest improvement for the least disruption.
Does the old door in your Lerwick kitchen whistle in the wind or leave puddles on the sill? Worn seals and failed drainage are common reasons to replace rather than repair.
- Removal and disposal of your old patio door is included in our guide prices, so there is no separate skip or tip run to organise.
- Slimmer modern frames often give a larger area of glass within the same opening, letting more daylight into the room than the old door did.
- Most two-panel replacements are completed in a single day, so the house is secure again by the evening without the room being out of use for long.
Light and sun in Lerwick
Daylight in Lerwick runs from about 5 h 49 min in December to 18 h 56 min in June, with the noon sun at roughly 6° and 53° respectively. Use that to choose your glass: standard low-E double glazing for north and east elevations, and consider solar-control or triple glazing for sunny south and west walls.
How much do replacement sliding doors cost in Lerwick?
Pricing is transparent and does not change because you are in Lerwick. The ranges below cover a standard-height door, fitted, with VAT; options are itemised in your quote.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| 2.1 m | 2 panels | £3,995–£4,895 |
| 3.0 m | 2 panels | £4,995–£6,095 |
| 4.0 m | 3 panels | £6,095–£7,395 |
See every size on the replacement sliding doors page or try the guide price tool.
What happens when you order replacement sliding doors in Lerwick?
Surveys in the ZE1 district are booked at a time that suits you. After you approve the quote, manufacture is typically 4–6 weeks for aluminium and 2–4 weeks for uPVC after survey sign-off; on fitting day the old door comes out, the new frame is set level and sealed, and the panels are adjusted so they glide properly. Fitting usually takes 1 day for a straight two-panel swap; 1–2 days for larger doors. Lerwick is in an area we cover by arrangement: the survey is still free, and survey dates, delivery and any travel cost for delivery and fitting are confirmed in your quote before you order.
Do you need approval in Lerwick?
In Scotland, replacing a door like for like in a house does not usually need a building warrant, but the new door must still meet the Scottish building standards for energy and safety. Forming or widening an opening is different: that needs a building warrant from the council before work starts.
Choosing the specification
- Upgraded glass. Triple, laminated, solar-control or obscure glass to suit the elevation.
- uPVC replacement. A cost-conscious choice for a straightforward swap, available in white and foiled colours.
- Aluminium replacement. A thermally broken aluminium slider with slim frames and a durable powder-coat finish.
Questions about replacement sliding doors in Lerwick
Is the price different in Lerwick?
The door price is the same as anywhere else. Because Lerwick is covered by arrangement, any travel cost for delivery and fitting is shown in your quote before you order; the survey itself is free.
Will the new door have a lower threshold?
A lower threshold may be possible on a replacement, depending on the floor level inside, the height of the patio or ground outside and how the opening was built. Low thresholds are typically 15–25 mm. A flush threshold needs a drainage channel outside so rain cannot run in. We check levels at survey and tell you what is realistic.
What happens to my old patio door?
We remove your old patio door and take it away for disposal as part of the job, and that is included in our guide prices, so there is nothing for you to arrange. If you would rather keep the old door, for example for a shed or greenhouse project, tell us before the fitting day and we will leave it safely on site.
What if there is no proper lintel above my old door?
Occasionally an old door frame turns out to be carrying some load because the support above the opening is inadequate or missing. We check the head of the opening at survey and again when the old frame comes out. If extra support is needed, we explain why, what it involves and what it costs before any further work goes ahead.