Internal pocket doors across Argyll and Bute
The right door depends on the opening, the room and the way you use the garden. Here is how internal pocket doors tend to work out in practice:
Renovating a period property in Argyll and Bute? Pocket doors can take panelled leaves that echo the existing doors, so the change looks considered rather than out of place.
Planning an open-plan kitchen in Argyll and Bute but still want to close it off now and then? A double pocket door gives you both.
- Soft-close dampers can slow the door in its final few centimetres in both directions, stopping it slamming shut or bouncing back out of the pocket.
- A double pocket door, with two leaves parting from the centre, opens up a wide doorway between a kitchen and a living area without any doors standing in the room.
- Reclaims the floor area a hinged door needs to swing, which in a small bathroom or cloakroom can be the difference between fitting a vanity unit and going without.
Guide prices for internal pocket doors in Argyll and Bute
These are guide prices for fitted doors, including VAT. They run from an entry-level system to a premium one at the same size; the survey confirms which suits your opening.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| Single pocket door | 1 leaf | £895–£1,595 |
| Double pocket door | 2 leaves | £1,695–£2,795 |
Every size is on the internal pocket doors page.
Daylight and glass in Argyll and Bute
Internal glazed doors are mostly about borrowed light. In Argyll and Bute, winter daylight lasts only around 6 h 57 min, so a glass door between a bright extension and a darker hallway or dining room can make a noticeable difference from November to February.
Towns we cover in Argyll and Bute
We survey and fit internal pocket doors in 6 towns across Argyll and Bute, including the G84, PA20, PA23, PA28, PA31, PA34 postcode districts.
Approvals in Scotland
In Scotland, fitting an internal sliding or pocket door is usually warrant-free; we use safety glass in glazed doors, and alterations to structural walls need a building warrant.
Questions about internal pocket doors in Argyll and Bute
Is the price different in Argyll and Bute?
No. Guide prices for internal pocket doors are the same across mainland Britain, including Argyll and Bute. The fitted price depends on size, system, glass and finish, and any structural work, all fixed in your written quote after survey.
How much wall space does a pocket door need?
A pocket door needs a length of clear wall beside the opening that is roughly the width of the door, plus a little extra for the frame. A double pocket door needs that space on both sides. The pocket section must be free of radiators, sockets, switches, pipes and cables, which is often the deciding factor in whether a particular doorway works.
Can a pocket door be fitted into an existing wall?
Yes, a pocket door can usually be fitted into an existing wall, but it involves opening up the wall beside the doorway. In a stud partition we remove the plasterboard, fit the pocket frame and board it again. In a masonry wall the usual approach is a new stud lining, and if the wall is load-bearing, forming the pocket becomes structural work that needs proper assessment and approval first.
What is an internal pocket door?
An internal pocket door is an interior door that slides into a cavity built inside the wall instead of swinging on hinges. The leaf hangs from rollers on a concealed track at the top of a pocket frame, and the frame is boarded and plastered so the wall looks normal. When the door is open, only its edge and pull remain visible.