Internal pocket doors across Glasgow and Dunbartonshire
A few practical points decide whether internal pocket doors suit a particular room and opening:
Where a Glasgow and Dunbartonshire house has solid brick internal walls, a pocket door is still possible, but expect a new stud lining and more making good than in a timber partition.
Planning an open-plan kitchen in Glasgow and Dunbartonshire but still want to close it off now and then? A double pocket door gives you both.
- The door leaf can be chosen to match the other internal doors in the house, such as painted panels, oak veneer or a glazed design, so it does not look out of place.
- Soft-close dampers can slow the door in its final few centimetres in both directions, stopping it slamming shut or bouncing back out of the pocket.
- Flush pulls sit level with the face of the door so the leaf can slide fully into the pocket, with a small edge pull to draw it back out again.
Guide prices for internal pocket doors in Glasgow and Dunbartonshire
These are guide prices for fitted doors, including VAT. They run from an entry-level system to a premium one at the same size; the survey confirms which suits your opening.
| Overall width | Typical panels | Guide price (fitted, inc VAT) |
|---|---|---|
| Single pocket door | 1 leaf | £895–£1,595 |
| Double pocket door | 2 leaves | £1,695–£2,795 |
Every size is on the internal pocket doors page.
Daylight and glass in Glasgow and Dunbartonshire
Light travels further than you might expect through internal glass. When the noon sun in Glasgow and Dunbartonshire sits at only about 11° in December, a glazed internal door lets light from a south-facing room reach the back of the house.
Towns we cover in Glasgow and Dunbartonshire
We survey and fit internal pocket doors in 8 towns across Glasgow and Dunbartonshire, including the G2, G61, G62, G64, G66, G81 postcode districts.
Approvals in Scotland
Internal doors do not normally need a building warrant in Scotland. We only supply safety glass for glazed doors, and any change to a structural wall would need a warrant, so we check the wall at survey.
Questions about internal pocket doors in Glasgow and Dunbartonshire
Is the price different in Glasgow and Dunbartonshire?
No. Guide prices for internal pocket doors are the same across mainland Britain, including Glasgow and Dunbartonshire. The fitted price depends on size, system, glass and finish, and any structural work, all fixed in your written quote after survey.
Can I put a light switch on the wall with the pocket?
Not on the pocket section itself, because the door slides through that cavity and there is nowhere to run a cable or fix a back box. Switches and sockets can usually move to the other side of the doorway or to an adjoining wall. We point out any that need moving at survey, and an electrician should relocate them before the pocket frame goes in.
How much does an internal pocket door cost?
Our guide price for a fitted internal pocket door is £895–£1,595 for a single and £1,695–£2,795 for a double, inc VAT at standard height. Where your door falls in that range depends on the leaf, the hardware, the wall construction and how much making good is needed. The final figure is fixed in a written quote after we have surveyed the wall.
Can a pocket door be fitted into an existing wall?
Yes, a pocket door can usually be fitted into an existing wall, but it involves opening up the wall beside the doorway. In a stud partition we remove the plasterboard, fit the pocket frame and board it again. In a masonry wall the usual approach is a new stud lining, and if the wall is load-bearing, forming the pocket becomes structural work that needs proper assessment and approval first.